JY888 Aquarium Silicone Sealant

Advantage:

Long shelf life

Non-sag

Excellent tooling characteristics for professional use

Readily gunnable both at low (+5 °C) and high (+40 °C) temperatures

Rapid crosslinking: quickly becomes tack-free and crack resistant

Flexible at low (-40 °C) and high temperatures (+150 °C) following cure

Low shrinkage on curing

Special high-viscosity paste

Excellent mechanical properties

1.Sealing Aquarium Glass Panels:

New Aquariums:Use the sealant to create a watertight bond between the glass panels.

Repairing Leaks:Seal cracks or gaps in existing aquariums.

2. Attaching Backgrounds and Decorations:

Backgrounds:Secure 3D or 2D backgrounds to the aquarium glass.

Decorations: Attach rocks, wood, or other decorations to the aquarium glass or substrate.

3. Creating Custom Aquascapes:

Rock Formations:Build intricate rock formations and caves.

Plant Anchoring:Secure plants to rocks or driftwood.

4. Repairing Equipment and Accessories:

Plumbing Leaks:Seal leaks in pipes and fittings.

Equipment Mounting:Attach filters, heaters, and other equipment to the aquarium glass.

Step 1: Make sure compatibility and adhesion between sealants and adhesive material before using.

Step 2: The sealant displays excellent adhesive effect in the clean environment with temperature of 4℃-40℃and Relative Humidity(RH)of40%-80%.

Step 3:Surface cleaning for bond substrates, clean up the dirt, grease and other contaminants, then affixedtemporary protective tape.

Step 4: According to the size you want, cut out sealant mouth.

Diameter of Gun nozzle should be smaller than the thickness ofthe sealant injection place, it makesnozzle can stretch into the 1/2 depth of the sealant injection place. Start to inject sealant whensubstrate surface is completely dry, Extrusion and injection of sealant shall be continuous ,whichmakes sure the extrusion of sealant is continuous and uniform cylinder, the move the gun slowly anduniformly, make sure the substrate interface is full of silicone sealant. Quick move is not allowed forthe gun, it will cases bubbles or holes.

Step 5: Decoration should be carried out when the injection is finished, and remove temporary protective tape.

1.Surface Cleaning

2.Affixed Tape

3.Sealant Mouth Cutting

4.Injection

5.Surface Fixing

6.Tape Remove

7.Finish